Transmission 1976-1991

Volvo 340/360 Torque Converter

The torque converter is a fluid coupling device in automatic transmission Volvos that transfers engine power to the gearbox while allowing the engine to idle independently. In models like the XC90, XC60, S60, and V70 with Aisin or Geartronic automatics, the torque converter multiplies torque during acceleration and locks up at cruising speed for efficiency. Durban's stop-start traffic and SA's varied terrain put significant stress on torque converters, making quality replacements critical for T5, T6, and D5-powered Volvos. We supply inspected Volvo 340/360 torque converter compatible with the 1976-1991 range, with warranty included and nationwide courier delivery.

WhatsApp Us

Warranty Included Nationwide Delivery Quality Tested

Part Type

Torque Converter

Fits

Volvo 340/360

Common Signs You Need a New Torque Converter

Shuddering or vibration when accelerating from a stop, especially noticeable in XC90 and XC60 models.

Slipping sensation where engine revs increase but the vehicle doesn't accelerate proportionally, common in high-mileage S60 and V70 automatics.

Overheating transmission with burnt fluid smell, often affecting older XC90 D5 models.

Unusual whining or grinding noise from the transmission bell housing area.

Poor fuel economy and sluggish acceleration, particularly in T5 and T6 turbocharged models.

Check engine light with transmission-related fault codes such as P0741 (torque converter clutch circuit).

You May Also Need

Complete Gearbox/Transmission Differential Assembly Valve Body Transmission Pump Clutch Disc Pressure Plate Flywheel Internal Clutches Planetary Gears Ring Gear

Common Questions About Torque Converter

Is it worth replacing a faulty torque converter on my Volvo XC90 or should I just scrap the car?

Replacement is usually worth it if the rest of the transmission is in good condition, as a faulty converter will eventually destroy the entire gearbox. For popular models like the XC90, XC60, and S60, quality used converters cost R3,500–R8,500, while full replacement with labour runs R12,000–R25,000 depending on model and workshop. Compare this to R80,000+ for a replacement transmission or the vehicle's resale value before deciding.

How much does a torque converter cost for a Volvo S60 or XC60 in South Africa?

Quality used torque converters for common models range from R3,500–R6,500 for S60/V70/XC70, R5,500–R8,500 for XC90/XC60, and R4,500–R7,000 for older S40/V50 models. Remanufactured units cost 30-50% more but include warranty, while new OEM converters from Volvo start around R18,000–R35,000. Labour for replacement typically adds R4,000–R8,000 depending on model complexity and whether the transmission requires removal.

Can a Volvo torque converter be repaired or does it need complete replacement?

Torque converters are sealed units and cannot be economically repaired in South Africa—replacement is the only reliable solution. The internal clutch plates, bearings, and fluid seals wear out and cause contamination throughout the transmission, so mechanics always recommend replacement rather than attempted repairs. For Volvo models, even specialists in Durban, Johannesburg, or Cape Town will source a replacement unit rather than try to rebuild the original.

Which Volvo models are most prone to torque converter problems?

First-generation XC90 (2002-2014) with the Aisin 6-speed automatic and D5 diesel engine are known for converter issues around 150,000–200,000km, particularly the lock-up clutch wearing out. Second-generation XC60 T5/T6 models and S60 II with 8-speed Geartronic can experience shuddering if service intervals weren't maintained. Older S80, V70, and S60 with 5-speed automatics also show converter wear after 180,000km, especially in SA's hot climate.

What causes torque converter failure in Volvo automatics?

Main causes include neglected transmission fluid changes (Volvo recommends every 60,000km despite "lifetime fill" claims), overheating from towing or mountain driving without transmission coolers, and contamination from worn clutch material circulating through the system. The lock-up clutch in converters for T5, T6, and D5 engines wears from repeated engagement cycles in heavy traffic, while metal particles from a failing converter will damage the entire transmission if not addressed promptly.