Engine Parts 2012-2019

Volvo V40 Connecting Rods

Connecting rods are forged steel or aluminium components that link each piston to the crankshaft, converting linear piston motion into rotational power. In Volvo engines like the T5 5-cylinder and D5 diesel, these rods endure tremendous forces—especially in turbocharged applications common in XC90 and S60 models. South African driving conditions, including high-altitude Johannesburg use and heavy coastal humidity in Durban, make proper oil maintenance critical to prevent rod bearing failure. We supply inspected Volvo V40 connecting rods compatible with the 2012-2019 range, with warranty included and nationwide courier delivery.

WhatsApp Us

Warranty Included Nationwide Delivery Quality Tested

Part Type

Connecting Rods

Fits

Volvo V40

Common Signs You Need a New Connecting Rods

Loud knocking or ticking noise from the engine that increases with RPM, often described as a metallic hammering sound

Low oil pressure warning light appears or oil pressure gauge reads abnormally low during operation

Noticeable loss of power and acceleration, particularly under load or during overtaking manoeuvres

Excessive engine vibration that wasn't present before, felt through the steering wheel and cabin

Metal shavings or glitter visible in the engine oil during routine checks or oil changes

Engine misfires or runs roughly at idle, with possible check engine light illumination

You May Also Need

Camshafts Crankshafts Pistons Valves Cylinder Heads Engine Blocks Timing Chains Timing Belts Rocker Arms Engine Bearings

Common Questions About Connecting Rods

How much does it cost to replace connecting rods on a Volvo in South Africa?

Connecting rod replacement typically costs R8,500–R18,000 depending on the Volvo model and whether you're doing a full set. For a 5-cylinder T5 engine (S60, V70, XC90), expect higher labour costs as the engine often needs removal. Diesel D5 engines require precision balancing, adding R2,000–R3,500 to the total.

Can I drive my Volvo with a damaged connecting rod?

Absolutely not—continuing to drive risks catastrophic engine failure where the rod punches through the engine block. This turns a R12,000 rod replacement into a R45,000+ engine replacement or rebuild. Stop immediately if you hear knocking sounds and have the vehicle towed to avoid total destruction.

Should I replace or recondition connecting rods on my Volvo XC90?

Reconditioning is viable if rods are only worn at bearing surfaces, costing R3,500–R6,000 for resizing and new bearings on a 5-cylinder engine. However, if rods are bent (common after overheating or severe detonation in T5/T6 turbos), replacement with genuine or quality aftermarket rods is mandatory for reliability.

What causes connecting rod failure in Volvo turbocharged engines?

Low oil level or degraded oil is the primary cause, starving rod bearings in high-stress T5 and T6 engines. Over-revving, detonation from poor fuel quality (a concern in rural SA areas), and hydrolock from water ingestion also bend or break rods. Maintain 10,000 km service intervals maximum for turbocharged Volvos.

Are connecting rods different between Volvo petrol and diesel engines?

Yes—diesel connecting rods like those in D5 engines are typically heavier-duty forged steel to handle higher compression forces (18:1 vs 9:1 in petrol). Petrol T5/T6 rods are lighter but engineered for higher RPM operation. Parts are not interchangeable between engine families, even within the same model range.